Measuring a room for flooring is not hard, and it helps you plan. You will have a rough idea of how much material you need, and you can compare products on the same footing. Here is how to do it with a tape measure, paper and a pencil.
What you need
- A tape measure long enough to cross the room
- Paper and a pencil, or graph paper if you have it
- A calculator
- A second person to hold the tape, if you can find one
Draw the room first
Sketch the shape of the room from above. It does not need to be to scale. Mark doors, closets, a fireplace, kitchen cabinets and anything else fixed to the floor. You will write each measurement on this sketch, which makes mistakes much easier to spot.
Measure a simple rectangle
Measure the length of the room along one wall, from wall to wall, not from baseboard to baseboard. Then measure the width. Multiply the two numbers to get the area.
For example, a room that is 12 feet long and 10 feet wide has an area of 120 square feet.
Measure each wall in two places if you can. Walls are often not quite parallel, and you should use the larger number.
Break an odd room into rectangles
Many rooms are L-shaped or have a bump out for a bay window or a closet. Split the sketch into rectangles with dotted lines. Measure each one, work out its area and add them together.
Say the main part of a room is 12 feet by 10 feet, and a closet off it is 6 feet by 2 feet. That is 120 square feet plus 12 square feet, or 132 square feet in all.
Do not forget the small spaces
- Closets, if the floor will run into them
- Doorways, where the floor continues to the middle of the door
- Hallways that connect the rooms
- The space under a refrigerator or a range, which usually gets flooring too
Flooring does not normally go under fixed kitchen cabinets, so leave those areas out.
Feet and inches
Mixing feet and inches is the most common source of errors. Pick one way and stick to it. An easy method is to round each measurement up to the next half foot. A wall that is 11 feet 4 inches becomes 11.5 feet. Rounding up gives you a small cushion.
Allow for cuts
You will need more flooring than the bare area. Planks are cut at the walls and around doorways, and some of the offcuts cannot be used. A room with many corners or a floor laid on a diagonal wastes more than a plain rectangle laid straight. The product instructions usually say how much extra to allow.
Flooring is sold by the box, and each box covers a set area. Divide your total, with the extra, by the coverage per box and round up to a full box.
Stairs are measured differently
Stairs are counted, not measured by area. Count the steps, then measure the width of a step, the depth of the tread and the height of the riser. Note any steps that are wider or curved, and any landings, which are measured as small rooms.
Things to note besides size
While you have the tape out, write down a few more details. They affect the job as much as the area does.
- What the floor is now, and how many layers you can see at a floor vent or a doorway
- Whether the room is on a concrete slab, over a basement or over a crawl space
- The floors in the next rooms and whether they are higher or lower
- Doors that swing over the floor and may need trimming
- Any spots that squeak, dip or feel soft
When to have a pro measure
Your own measurements are good for planning and for comparing products. Before any flooring is ordered, have the installer measure. They will check the same things again, plan the layout and take responsibility for the amount ordered.
Roomview Floors measures in person on every job. Call or send a request and we will bring samples at the same visit.